The site view displays the selected drilling plan. The way in which the drilling plan is presented can be selected with the Site button in the side menu. The 2D/3D icon below the button indicates which mode is selected.
To access the site selection and creation view, click the Drilling plan button in the start or side menu.
By selecting a hole in the drilling field, you can navigate directly to measuring the hole in question or viewing a measured hole. Measured holes can also be moved, deleted and supplemented with additional data.
In the 3D view, the bottoms of the boreholes are assumed to be at equal depth. The ground level in the 3D view is determined based on the measurements conducted. It can then be used to facilitate finding holes and to draw a graphical presentation of a hole's direction and azimuth. In other words, the vertical alignment of the holes is derived from the bottom and is horizontal in relation to the surface.
During hole measurement, the starting direction is always assumed to be the same, so all the holes in the field begin in the same direction: directly up. If the starting direction of a hole differs from the assumed direction, the graphical presentation will not match the drilled hole. The starting angle is defined before drilling and set as the hole's starting angle for measurement.