Operating principle

The Robit Sense measurement software is a versatile tool for measuring boreholes. The measurement data can be saved in a database, where it can be viewed after drilling or at a later time.

Holes can be measured in two ways: 1) select a site and field before measurement, which allows you to define what hole to measure, or 2) drill and measure a hole first and decide afterwards whether or not you wish to save it in a site. All holes measured in a field can be viewed simultaneously, which provides a good overall view of the holes throughout the field. A measured hole does not need to be connected to a worksite. Instead, it can be saved in the database separately.

Selecting a field before drilling a hole

  1. Select the site, level and field.
  2. Select the hole to be drilled.
  3. Press the Drill here button.
  4. Drill the hole normally.
  5. Once the hole has been drilled, press the Start lifting the rods button.
  6. Enter the starting angle and length of the hole.
  7. Maintain the rod stationary for the time shown on the screen.
  8. Mark rod replacement points using the rod replacement button.
  9. Once the drill has been lifted, the hole measurement data is transferred to the computer.
  10. The data for the drilled hole is linked to the selected hole automatically.

Drilling without selecting a field

  1. Press the Start drilling button.
  2. Select the measurement module.
  3. Press the Drill new hole button.
  4. Drill the hole normally.
  5. Once the hole has drilled, press the Start lifting the rods button.
  6. Enter the starting angle and length of the hole.
  7. Maintain the rod stationary for the time shown on screen.
  8. Mark the rod replacement points using the rod replacement button.
  9. Once the drill has been lifted, the hole measurement data is transferred to the computer.
  10. Attach the measurement data to the hole.
    1. Download the data from the measurement module.
    2. Select the worksite, level and field where the data is to be saved. If you do not select a site for the hole, it will be saved independently in the database.
    3. Select the hole from the drilled field.
    4. Link the transferred information to the drilled hole.
Parent topic: System description